{"id":38142,"date":"2020-02-12T09:45:47","date_gmt":"2020-02-12T14:45:47","guid":{"rendered":"https:\/\/k-rp.com\/esp-tutorial-5"},"modified":"2020-02-12T09:45:47","modified_gmt":"2020-02-12T14:45:47","slug":"esp-tutorial-5","status":"publish","type":"post","link":"https:\/\/k-rp.com\/fr\/esp-tutorial-5","title":{"rendered":"ESP+ Tutorial #5 \u2013 Connect ESP+ to a LAN"},"content":{"rendered":"

Available on most KeepRite Refrigeration evaporators<\/span><\/a>, the ESP+ Intuitive Evaporator Control Technology<\/span><\/a> is designed to replace traditional electro-mechanical refrigeration controls typically used on medium and low-temperature applications. <\/span><\/p>\n

Among many other benefits, the ESP+ features a quick and simple installation including connecting it to a local-area network (LAN). <\/span><\/p>\n

IP Address Sticker Available<\/span><\/h2>\n

To begin, connect your ethernet cable to the ESP+ control board as well as to an open port on the network switch or a router. <\/span><\/p>\n

Following this, you will want to use the control display system on your ESP+ to enable the DHCP setpoint. To access the setpoint menu, press and hold the \u201cback\u201d button for three seconds and then use the \u201c<\/span>\u2227<\/span>\u201d and \u201c<\/span>\u2228<\/span>\u201d arrows to find the \u201cdHC\u201d setpoint. <\/span><\/p>\n

Press and release \u201cEnter\u201d to display the current setting and use the \u201c<\/span>\u2227<\/span>\u201d and \u201c<\/span>\u2228<\/span>\u201d arrows again to find enable \u201cEnA\u201d. To confirm the setting and enable DHCP, simply press and hold \u201cEnter\u201d for three seconds. To return to the home screen repeatedly press the \u201cBack\u201d button.<\/span><\/p>\n

Next, you will need to find and record the controller IP address which is a series of four numbers. The IP address is shown on a sticker on the Service Parts List on the access panel. <\/span><\/p>\n

Once you have those four digits you will need to hop on a computer connected to the same network as the ESP+ controller and open a new browser, either wired or wireless. Enter the controller IP address into the address bar of your opened browser and press enter.<\/span><\/p>\n

The ESP+ controller homepage should now be displayed. If for some reason the page does not load, additional setup or IT support may be required. If you wish to make any changes to passwords, unit settings, etc., you will need to first login into the dashboard.<\/span><\/p>\n

If this is your first time accessing the controller be sure to use the default username of \u201cke2admin\u201d and password \u201cke2admin\u201d. Otherwise, you can use the username and password you previously set or were supplied with.<\/span><\/p>\n